U-Line CLR2060 - Manual (Page 23)

21
Install the insert as follows:
Insert edges may be
SHARP! Use care when
installing.
1. Remove top hinge screw pin
(7/64" Allen wrench, see Figure
22). Remove door by tilting
forward and lifting off bottom
hinge pin.
2. Pull door gasket out of groove
(top edge of door only). Start in
the middle and pull outward, mov-
ing toward the edge (see Figure
23). This may take some force.
Do not remove the three screws
behind gasket.
3. Remove two outside screws hold-
ing door handle. Slightly separate
door handle from door (Figure 24).
4. Pull handle up and off. Remove
outer door panel and cardboard
spacer.
5. Slide custom door panel insert
into 1/4" channel in door front.
6. Holding door gasket out of the
way, replace handle on door
making sure it is seated prop-
erly on insert and that screw
holes line up.
7. Install two small screws
removed in step 3.
8. Starting at the corners and
working inward, push door
gasket into place on door.
9. Place door on bottom hinge pin
and install upper hinge screw.
! WARNING
UL310
DWR020
UL132
Figure 22
Figure 23
Figure 24
Body_UM.qxd 12/17/04 9:16 AM Page 21