Uniden UBCD996T User Manual

Page 14

Advertising
background image

Memory Backup

Temporary Lockout

Startup Configuration

Single-Handed Function Control Operation

Record Out Jack

Display and Keypad Backlight

Vehicle Power Connection (Orange Wire)

Trunk Tracker IV™ Operation

Multi-Site Trunking

Control Channel Only Scanning

Adaptive Digital Threshold

Location Based Scanning

GPS Non-Radio Based Features

GPS Display Mode

— If power is lost or disconnected, the scanner retains the

frequencies you programmed in its memory.

— Makes it easy to temporarily lock out a system, channel, or

frequency. The lockout is cleared when you turn power off, then back on so you

don’t have to remember to unlock the channels later.

— Lets you easily manage multiple configurations for your

scanner.

— You can tap the Function/Scroll

Control to enable the Function mode. It reverts to normal mode in about 3 seconds

from your last press if no other action occurs.

— Using the appropriate cable and audio recording device with

signal control, you can record live audio of designated channels.

— Makes the display and keypad easy to see in

dim light using two color options and six light levels plus off.

— Lets you connect to your vehicle’s

dimmer circuit to also dim the scanner’s display with the vehicle’s dimmer control.

— Follows unencrypted conversations on analog

Motorola, Motorola Astro 25 (APCO 25), EDACS, EDACS SCAT, and LTR trunked

radio systems, including systems in VHF, UHF, 700 MHz, 800 MHz, and 900 MHz

bands. The scanner can scan both conventional and trunked systems at the same

time.

— Lets you share system channels across multiple sites to

more efficiently use the scanner’s memory and more easily select sites to monitor.

— If the scanner is set to scan a Motorola

system, you can set it so it scans using only control channel data. You do not have

to program voice channel frequencies into memory in this mode as long as all

possible control channels are programmed.

— Automatically sets the digital decode threshold for

APCO 25 systems.

— If you connect a GPS unit to the scanner it can

automatically enable and disable systems based on the Location Information

(longitude, latitude, Range) that you provide.

— The scanner alerts you to Dangerous

Intersections, Speed Alerts, and Points of Interest that you program into the scanner.

— Lets you display extended GPS information such as

GPS

14

Advertising