Uniden UBCD996T - Manual (Page 56)

56
- Polarity
Manual High Middle Low
Off
Settings
Set Backlight
Set Color
Settings
Adjust Key Beep
Auto
Level 1 15
Off
Settings
Set Audio AGC
Analog
On
Off
— If the headlight wire is connected to vehicle ground when the
headlights are on, pick this setting.
— Use this setting to manually set the dimmer level to , , ,
or . To guide you in your selection, at each setting the display shows what you
can expect to see.
Set this option to either Red or Green.
— the scanner automatically sets the key beep to match the master volume
setting level you select.
- — the scanner lets you manually select one of fifteen key beep
levels. As you turn the , the beep gets louder. Press when you reach
the desired level.
— the scanner turns the key beep off.
This setting helps balance the audio level you hear as you listen to different radio
sources so you can hear them at a similar volume. Use this setting if you listen to an
audio source that has natural changes in audio level for which you want to
compensate.
You can set the Analog or the Digital mode to be on or off.
to select either on or off specifically for receiving analog channels.
— Press to select.
— Press to select.
Setting the Backlight Color
[MENU]
[MENU]
Scroll Control
[MENU]
Adjusting the Key Beep
Setting the Audio AGC