Uniden UBCD996T - Manual (Page 33)

33
WARNING!
BNC Antenna
Connector
REC
All Channel
Marked Channel
Use only the Uniden-supplied AC adapter with this scanner.
Insert the connector of the supplied indoor telescoping antenna to the
and apply moderate pressure to secure it.
It is best if you plan ahead when you initiate the basic setup of the scanner if you
include the components to record incoming reception. You need only an audio
recording device which can be control by a Voice Operated module (VOX) either
externally or from within the unit and the correct connecting cable.
The jack on the rear apron provides a constant-level audio output which is not
affected by the setting of the volume control. Use a mono or stereo cable that ends
in a 3.5mm plug for the scanner. The recorder might have its own requirements as to
the proper plug Check the recorder’s instructions to be sure.
Connect the cable to an external or internal VOX control so that the recorder
activates when audio is present.
You can also connect the cable to the appropriate input jack on your PC so that with
controlling software, you can record to your hard disc.
In order for the function to operate, you must set the channel to record. You must
also set the system’s record option to either , which will record all
channels regardless of any channel’s setting, or which only lets
recording occur if you have selected record for that channel. Which you choose will
depend on various factors.
You can mount your scanner in your vehicle, using either the supplied bracket or the
supplied DIN-E sleeve.
With the bracket removed from the radio, use the holes in the bracket as a template
to initially mark the location you plan to use in your vehicle. Be absolutely certain of
what might be behind the mounting surface before making any holes, be it above, or
below, or in front of your dash, armrest console, or other location. If you drill
carelessly, expensive damage can result. If in doubt, consult your vehicle dealer’s
service department or a qualified professional installer.
Setting Up an Audio Recording Device or Computer
Recording
Vehicle Installation
Mounting Using the Bracket