Uniden UBW2101 - Manual (Page 18)

18
FCC Compliance Information
Part 15 Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subjected to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class
B digital device, pursuant to Part 15 of the FCC rules and ETSI (EN) 300328.
These limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television
equipment reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
x Reorient or relocate the receiving antenna.
x Move the equipment away from the receiver.
x Plug the equipment into an outlet on a circuit different from that to which the
receiver is connected.
x Consult the dealer or an experienced radio/television technician for additional
suggestions.
CAUTION! Any changes or modifications to this equipment not
expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
RF Exposure Information
The antenna used for this transmitter must be installed to provide a separation
distance of at least 20 cm (7.9”) from all persons and must not be collocated or
operating in conjunction with any other antenna or transmitter.
IC Compliance Information
Radio Equipment Notice
The term “IC:” before the radio certification number only signifies that Industry
Canada technical specifications were met. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired
operation of the device. “Privacy of communications may not be ensured when
using this device”.
CE Compliance Information
Products with CE Marking comply with EMC Directive (2004/108/EC); low voltage
Directive (73/23/EEC); R&TTE(1999/5/EC) issued by the Commission of the
European Community. Compliance with these directives implies conformity to the
following European Norms:
x EMC: EN 301 489
x LVD: EN 60950
x Radio: EN 300 328