Uniden BR330T - Manual (Page 62)

62
6. Set the CTCSS/
DCS code, then
press E
7. Press E to enter
advanced options
(Steps 8-11) or
press to skip to
Step 12.
8. Set the modulation
type (Auto is
almost always the
correct choice),
then press E
9. Set the attenuator
(turn it on to
eliminate
interference from
other sources), then press E
10. Set the channel
priority (turn it on if
you want the
scanner to interrupt
operation every few
seconds to check
for transmissions by
this driver), then press E
11. Set alert (turn it on if
you want the
scanner to sound a
special alert when
this car transmits),
then press E
Set CTCSS/DCS
Off
Advanced Options
Yes=“E”/ No=“.”
Set Modulation
Auto
Set Attenuator
Off
Set Priority
Off
Set Alert
Off