Universal Metal Industries UL2836 - Manual (Page 6)

Item No. 0AL00-UL-001 Revised 10/05/04 Copyright (C) 2004, Universal Metal Industries, Inc. Page 6
PART 4 Use and Care
OPERATING CONTROLS:
Always activate the ventilator when using cooking appliances. Activate the ventilator a few minutes before starting
to cook to establish an airflow pattern within the room. Adjust the fan speed as needed. Adjust the dimmable
halogen lights as desired. Eliminate air currents in the hood vicinity by shutting nearby windows and doors, turning
off ceiling fans and adjusting the adjacent heating and air conditioning outlets if necessary. Place your largest pans
on the rear burners whenever possible.
WARNING!
Do NOT operate the blower / ventilator system without the filters in place, or with dirty, grease laden filters.
ENERGY SAVING TIPS:
Do not operate the blower at a speed higher than necessary to remove the cooking exhaust. Running at excessive
speeds removes more air from the inside of the house that must be replaced by outside air. This may be especially
costly when your home’s heating or air conditioning system is in operation. Turn off the unit once the smoke and
cooking odors have been eliminated. Clean filters and grease laden surfaces often to improve efficiency. Always
use lids on cookware to retain heat and moisture. Minimize the amount of liquid used to cook food. Select
cookware of proper size, material and construction for the cooking task being performed.
CARE & CLEANING:
Proper cleaning is necessary to maintain performance and appearance, while also ensuring safe operation.
The frequency of cleaning should be adjusted according to the type and amount of cooking. Best results will be
achieved by cleaning soiled components as soon as possible. Filters must be cleaned regularly. Remove one filter
at a time by inserting a butter knife in the slot and pressing back then downwards. Butter knife filter slots are a
safety feature. The filter should be installed with the butter knife slot on the front lower side.
The filters may be cleaned by hand washing in hot water using a mild detergent solution, or by placing them in a
dishwasher. Dry the filters completely before using again. Stainless steel surfaces should be cleaned with a
solution of mild detergent and warm water. Rinse and dry with a soft lint-free cloth. Charcoal filters are ineffective if
washed and should be replaced periodically. Contact your dealer or Universal Metal Industries for replacement.
CAUTION: If a commercially available stainless steel cleaner is used, it is important to read the labels for chlorine
compounds. Chlorine is a corrosive substance. If these compounds are present, rinse thoroughly and dry with a
soft lint-free cloth. Follow polish manufacturer’s instructions. Always wipe stainless steel surfaces with the grain.
Never wipe across the grain. After cleaning, reinstall the filters carefully. Most common scrubber type pads will
scratch the hood.
HALOGEN LIGHT BULBS:
UM200 hoods are designed for Par 20 halogen lamps. They can be purchased at most home and/or grocery
stores, e.g., Lowe’s, Menards, Fry’s, Kroger, Ace Hardware, Albertsons, True Value, and Home Depot.
Universal Metal Industries, Inc. has a policy of continuous improvements and reserves the right to modify (at any
time, without notice) any or all of its products, features, designs, components and specifications. For exact
dimensions, see the installation instructions included with each product. Some features may be slightly different
than shown on product literature.
For questions regarding this product contact:
Customer Service
Universal Metal Industries, Inc.
P.O. Box 2409
Phoenix, AZ 85002
(602) 251-3654
umiphx.com / customrangehoods.com / artechusa.net