Universal Electronics MILLENNIUM 3 - Manual (Page 12)

PROGRAMMING VCR CONTROL
NOTE: If you own a TV/VCR combination, skip this section and
perform “Programming TV/VCR Combo Control” on page 16.
Locate the brand name of your VCR in the Setup Codes For
VCRs section below, and write it in the following space.
VCR Brand: __________________________________
The brands are listed in alphabetical order with the most
popular codes listed first.You will use one of these codes
to program the Millennium 3 to operate your VCR:
1. Turn on your VCR and insert a video cassette.
2. On the Millennium 3, press VCR once. Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3. Enter the first four-digit code for your VCR. If
you perform this procedure correctly, the LED
will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 3 at your VCR and press
VCR once. The VCR should turn off. If your VCR
remote control does not have a POWER
key, press PLAY. If the VCR does not respond,
repeat steps 2-3, trying each code listed for your
brand until you find one that works. If the VCR
still does not work , try searching for the code
(see Searching For Your Code on page 22).
5. Write your VCR code in the boxes below for
future reference.
NOTE: Remember, to use the Millennium 3 to operate your VCR,
press VCR first.
Setup Codes for VCRs:
Admiral 0048
Adventura 0000
Aiko 0278
Aiwa 0037, 0000, 0307
Akai 0041, 0061, 0106
American High 0035
Asha 0240
12
Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 12