U-Line CO75 - Manual (Page 14)

14 CO29, CO75
Door Reversal
CO29:
Depending upon the location of the unit, it may be
desirable to change the side on which the door is
mounted. NOTE: On built-in installations, changing the
door mounting to the left side may interfere with ice
bucket removal.
To reverse the door mounting, perform the following:
Figure 20
1. Remove the control knob (Figure 20, 1) by pulling it
away from the cabinet.
2. Remove two grille screws, and remove the grille.
Figure 21
1. Remove top hinge from cabinet (three screws) (Figure
21). Hold door to keep it from falling.
2. Lift the door off the bottom hinge.
Figure 22
3. Remove bottom hinge from cabinet (two screws)
(Figure 22).
Figure 23
4. Remove screws on opposite side of cabinet (Figure 23).
Note that there may be a nut behind one or both
screws on either side.
Figure 24
5. Install hinge on opposite side, bottom of cabinet
(Figure 24). Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
1
ULIN_0014_A
ULIN_0210_A
ULIN_0215_A
ULINE_0216_A
ULINE_0217_A
ULIN_016357_30089.fm Page 14 Monday, March 27, 2006 10:25 AM