U-Line CO75 - Manual (Page 17)

CO29, CO75 17
8. Relocate plastic spacer/bushing on bottom of door to
the opposite side (Figure 35). Clean out bushing hole
in door bottom if necessary.
Figure 36
9. Place door on lower hinge pin. Align flat edge of top
hinge with outer edge of unit and fasten upper hinge
to unit (four screws). Partially tighten screws (Figure
36).
10. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
11. Replace four plastic plugs removed in Step 4 into holes
on top of unit. Replace screws in holes in bottom of unit
on opposite side.
Glass Shelf Removal/Installation
Remove the shelves as follows:
Figure 37
1. Pull shelf out about 6" until back of shelf clears the
“hump” on the right hand side.
2. Tilt right hand edge of shelf up and remove shelf from
unit by pulling out.
Insert the shelves as follows:
1. Insert shelf at an angle, approximately 15-20°, over the
rib in the side of the unit where you want to place the
shelf. The shelf must be started into the unit at an
angle to clear the door.
2. Continue to slide the shelf into the unit at an angle
until it clears the door.
3. Lower the shelf and push it in completely.
ULIN_0223_A
ULIN_0232_A
ULIN_016357_30089.fm Page 17 Monday, March 27, 2006 10:25 AM