U-Line CO75 - Manual (Page 16)

16 CO29, CO75
CO75:
NOTE: The grille should not yet be installed. If it has been
installed, remove it for door reversing.
To reverse the door on black models:
Figure 30
1. Remove top hinge from cabinet (four screws) (Figure
30). Hold door to keep it from falling.
2. Lift the door off the bottom hinge.
Figure 31
3. Remove four plastic plugs in hinge holes, top of cabinet,
opposite side, being careful not to scratch cabinet
(Figure 31).
Figure 32
4. Remove four plastic plugs in hinge holes, invert screw
and reinstall pivot screw in top hinge (Figure 32). Do
not install hinge on cabinet at this time.
Figure 33
5. Remove bottom hinge from cabinet (four screws) and
screws on opposite side of cabinet (Figure 33).
6. Remove pivot screw from bottom hinge, invert screw
and reinstall pivot screw in hinge (Figure 32).
Figure 34
7. Install bottom hinge on cabinet, opposite side, aligning
flat edge of hinge with outer edge of unit. Partially
tighten screws (Figure 34).
Figure 35
ULIN_0218_A
ULIN_0219_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0106_A
ULIN_0220_A
ULIN_0221_A
ULIN_0222_A
1
ULIN_016357_30089.fm Page 16 Monday, March 27, 2006 10:25 AM