UNICOM Electric Micro Net 5 - Manual (Page 4)

■ DC Power Connector
Plug the female connector into the switch and the male connector into
a power outlet. Supports input voltages 9 VDC at 700 mA.
LED-Indicators
Figure 4. Front panel view of LED indications
Table lists each the LED and its function.
LED Status Color Description
Power On Green The switch is supplied with
suitable power.
On Orange The por t is connecting in
Full Duplex
A packet collision ocurred at
FDX/COL Blinks this por t. In half-duplex mode,
collisions may occur more
often than in full-duplex mode.
Off The port is operating in Half
Duplex mode.
On Green The por t is connecting at
10Mbps.
LINK/ACT Blinks The por t is receiving or
transmitting data.
Off The port is not linked
successfully with the device.
Hardware Description
The Front Panel
The front panel consists of LED Indicators.
Figure 2. Front Panel view of Micro-Switch/5
LEDs
Per Device: Power
Per Por t: LINK/ACT (Link/Activity)
FDX/COL (Full Duplex/Collision)
The Rear Panel
The rear panel view of the 5-Por t Switch ( Auto MDI/MDIX ) consists
of a DC power connector and 5 auto-sensing por ts.
Figure 3. Rear panel view of the Micro-Switch/5
■ RJ-45 Por ts ( Auto MDI/MDIX ):
5 ports of 10/100 N-way auto-sensing for 10Base-T or 100Base-TX
connections. [ In general, MDI means connecting to another Hub or
Switch while MDIX means connecting to a workstation or PC. Therefore,
Auto MDI/MDIX means that you can connect to another Switch or
workstation without changing pin-to-pin or crossover cabling. ]
3 4
LINK/ACT
FDX/COL
1 2 3 4 5
Power
Micro-Switch/5
5 Port 10/100Base-TX Switch
1 2 3 4 5 DC IN
LINK/ACT
FDX/COL
1 2 3 4 5
Power
Micro-Switch/5
5 Port 10/100Base-TX Switch
LINK/ACT and FDX/COL Indicators
Power Indicator