UNICOM Electric FEP-32024T - Manual (Page 9)

6
Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby.
The surface should be clean, smooth, level, and sturdy. Ensure there is
enough clearance around the Switch to allow air circulation and the
attachment of the power cord and cables.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Switch is grease and
dust free.
B. Remove adhesive backing from your Rubber Feet.
C. Apply the Rubber Feet to each corner on the bottom of the Switch. These
footpads protect the Switch from shock and vibration.
Figure 2-4. Attaching Rubber Feet to each corner on the bottom of the Switch
Power On
Connect the power cord to the power socket on the rear panel of the Switch.
The other side of power cord connects to the power outlet. The internal
power supply in the Switch works with AC in the voltage range 100-240VAC,
frequency 50~60Hz.Check the power indicator on the front panel to ensure
that power is properly supplied.