Philips HF3475 - Manual (Page 8)

Note: Be aware that, if you do not turn the wheel for 5 seconds when you are in the menu (SET), the
appliance automatically leaves the menu and displays the clock time again.
You can operate the function selection wheels in the following way:
1 Press one of the function selection wheels to activate the selection mode (Fig. 5).
 Turn the same function selection wheel up and/or down to select a setting (Fig. 6).
Note: You can also turn the top wheel (light intensity wheel) and the bottom wheel (volume wheel) up
and down to select a setting without pressing the wheel first.
 Press the same function selection wheel again to confirm the selected setting.
Before first use
1 Place the appliance at 0-50cm from your head, for example on a bedside table (Fig. 7).
 Put the plug in the wall socket.
The hour indication on the display starts flashing to indicate that you have to set the clock
time (Fig. 8).
setting the clock
1 Turn the middle selection wheel (SET) up and/or down to select the hour.
Note: You can only do this when you are in the set clock menu and when the hour indication flashes. If
this is not the case, press the middle selection wheel (SET) two times. You are now in the set clock menu.
 Press the middle selection wheel (SET) to confirm.
The minute indication starts flashing (Fig. 9).
 Turn the middle selection wheel (SET) up and/or down to select the minutes.
 Press the middle selection wheel (SET) to confirm.
The appliance leaves the menu and the display shows the set clock time.
The appliance is now ready for use.
Note: Every time you remove the plug from the wall socket for more than 15 minutes, you have to set
the clock time again in the way described above. To change the set clock time when the plug is still in the
wall socket, see section ‘Menu functions of middle selection wheel (SET)’ in chapter ‘Using the appliance’.
using the appliance
using the lamp
You can use the appliance as a bedside lamp.
1 To switch on the lamp, press the top selection wheel (1). Then turn it to select the light
intensity level you prefer (). (Fig. 10)
You can choose a light intensity between 1 and 20.
Note: It takes approx. 1 second for the lamp to go on. This is normal, the lamp needs to heat up.
Note: The light intensity you have selected is automatically set as the light intensity level for the alarm as
well.
Tip: When you use the appliance for the first time, set the light intensity to 20. The moment you wake up,
check which light intensity level the appliance has reached by slightly turning the top selection wheel.
When you do this, the current alarm light intensity level appears on the display. Set the alarm light
intensity to this level for the next day.
 To switch off the lamp, press the selection wheel again.
,
,
,
EnglisH 8