ViewCast Osprey-450e - Manual (Page 23)

Osprey 240e/450e User Guide
ViewCast 17
Video input
The Video Input (Figure 16) lets you select the video signal source from a drop-down list.
Figure 13. Video Input field
Osprey 240e
The Osprey 240e is a single channel card. It has multiple video inputs, but you can select only one of
them at a time. The inputs that are selectable depend on the type of dongle used. Two types of dongles
are available for this board – Composite/SVideo, and YPrPb.
The connections for the Composite/SVideo dongle are shown in Figure 14.
Figure 14. Composite/SVideo dongle connections
The YPrPB dongle is primarily for YPrPb (Component) inputs, as shown in
Figure 15. YPrPb dongle connections
The blue Pb input can also be used as a Composite input. The driver should be set to Composite when thePb input
is used this way.
Osprey 450e
The Osprey 450e has four separate independent video channels that can run simultaneously. You can
use the board with or without an optional auxiliary expansion connector.
When the expansion connector is not installed, the only video inputs available are the Composite BNC
inputs on the board’s mounting bracket. The four connectors correspond from top to bottom to
channels A, B, C, and D. In this case, the Video Input control shows just the one input for each channel,
which is selected automatically.