Installation, Continued – Vanguard VMH26TNC User Manual

Page 11

Advertising
background image

www.desatech.com

113111-01H

11

IMPORTANT: When finishing your firebox,
combustible materials

WARNING: Do not allow any

combustible/noncombustible

materials to overlap the firebox

front facing.

WARNING: Do not allow

noncombustible materials to

cover any necessary openings

like louvered slots.

WARNING: If pre-wiring, do

not connect wiring to any electri-

cal source at this time.
Install fireplace electrical outlet

and connect wiring to outlet

before connecting to electrical

source. The fireplace electri-

cal outlet is included with the

GA3450T blower accessory.
Only use the fireplace electri-

cal outlet supplied with the

GA3450TA blower accessory.

2. If installing GA3450TA blower accessory,

do so at this time. See Installing Blower
Accessory GA3450TA,
page 13.

Note: If not installing blower accessory,
you may wish to run electrical wiring to
your fireplace for future blower installa-
tion (see Accessories, page 29) Use only
approved three-wire electrical wiring.

Note: A qualified installer should make all
electrical connections.

3. Install gas piping to fireplace location. This

installation includes an approved flexible
gas line (if allowed by local codes) after
the equipment shutoff valve. The flexible
gas line must be the last item installed on
the gas piping.

4. If you have not assembled firebox, follow

instructions on page 4.

5. Carefully set fireplace in front of rough

opening with back of fireplace inside wall
opening.

6. Attach flexible gas line to fireplace gas

regulator. See Connecting to Gas Supply,
page 16.

7. Bend four nailing flanges on outer casing

with pliers (see Figure 10).

8. Attach fireplace to wall studs using nails

or wood screws through holes in nailing
flange.

9. Check all gas connections for leaks. See

Checking Gas Connections, page 18.

10. If using optional trim kit, install the trim

after final finishing and/or painting of wall.
See instructions included with trim acces-
sory for attaching trim.

InsTallaTIon

Continued

36

5

/

8

"

25

7

/

8

"

51

3

/

4

"

26

7

/

8

"

Figure 9 - Rough Opening for Installing

in Corner

26

7

/

8

"

26

7

/

8

"

3/4" Off
The Floor
Minimum

10

1

/

2

"

Figure 8 - Rough Opening for Installing

in Wall

Figure 10 - Attaching Fireplace to Wall

Studs

Nails or
Wood
Screws

Nailing
Flanges

Advertising
This manual is related to the following products: