Velodyne Acoustics VRP Series User Manual

Page 13

Advertising
background image

T roubleshooting and Service

10

.

w w w . v e l o d y n e . c o m

VRP User’s Manual

If you should experience a problem with the operation of your subwoofer, please check all of the
following before seeking service. Following is a simple troubleshooting guide to assist you.

1. Verify that the unit is plugged in, the power outlet is active, and is supplying

proper voltage.

2. Is unit receiving an input signal from your source?
3. Have all controls on subwoofer (volume, crossover, phase, etc.) been properly set?
4. If unit has been running at high levels for an extended period of time, one of the

protection circuits may be engaged.

• Is the built-in amplifier extremely hot to the touch?
• Is your power line voltage sagging, such as when there are other devices on the

same circuit drawing lots of power?

If the protection circuitry is active, the unit may cycle on and off until operating parameters
return to normal. Under more serious conditions, the unit may shut off completely. Normal
operation should return upon cooling, but you may be required to turn the power off and then
on again to reset the unit.

The following conditions require service by a qualified technician:

1. The power cord has become damaged.
2. The unit does not appear to operate normally or exhibits a marked

change in performance.

3. The unit has been exposed to water.
4. Some part of the cabinet or circuitry is physically damaged.

Thank You for Purchasing a Velodyne!

Advertising