Verbatim MediaStation Network Multimedia Hard Drive - Manual (Page 15)

15
3.2.2 Audio Setup
This is guide for setting audio output of MEDIASTATION. You can use Stereo or Digital 5.1 ch..
3.2.3 Network Setup
It is possible to obtain IP address automatically from DHCP Server or IP Router, or set the specifi c IP address. Check your network
environments.
Setup Procedure
Setup Procedure
① Turn on MediaStation and press [SETUP] on Mode Selection screen.
① Turn on MediaStation and press [SETUP] in Mode Selection screen.
② Move to ‘TV Out’ icon and press [ENTER]. Setup box will be displayed under icon
menu.
③ Move to Video Output Mode that you want and press [ENTER].
④ Finally, press [SETUP] again for saving confi gurations.
② Move to ‘Audio’ icon and press [ENTER]. Setup box will be displayed under icon
menu.
③ Move to Audio Output Mode that you want and press [ENTER].
④ Finally, press [SETUP] again for saving confi gurations.
✓ Analogue/DCPM: Select when you connect the supplied audio cables (Red / White) to TV or Audio set directly.
✓ Encoded Digital: Select when you want to listen through 5.1Ch / DTS Dolby by connecting receiver (or amplifi er) with Optical or Coaxial cable.
✓ DHCP On: You can use this option when it is possible to obtain IP address automatically from DHCP Server or IP Router.
✓ DHCP Off: When it is not possible to obtain IP address automatically or you connect to your PC directly without DHCP Server or IP Router, you have to use this option. Just enter the
IP address and Subnet mask.
‘DHCP On’ Setup Procedure
① Turn on MediaStation and press [SETUP] in Mode Selection screen.
② Move to ‘Network’ icon and press [ENTER]. Setup box will be displayed under icon
menu.
③ Move to DHCP On and press [ENTER].
④ Finally, press [SETUP] again for saving configurations.