Vision Fitness X6100 - Manual (Page 7)

7
3
STEP
• Remove the screws for the water
bottle cage in the center of the
console mast. Slide the rubber boot
onto the console mast.
• Unfold the wire harness located in
the frame bracket. Wrap the wire tie
around the end of the wire
harness. Pull the wire tie and wire
harness up through the top of the
console mast while simultaneously
sliding the mast into the frame
bracket. NOTE: For the X6000, the
tension cable should also run up
through the console mast.
• Secure the mast to the frame using
three lock washers (M8.2x14.1.5T)
and three capscrews (M8x60L).
Tighten with the 6
MM Allen wrench.
• Slide the rubber boot down the
console mast and snap it in place on
top of the side cover.
X6000 ONLY: Turn the tension knob to
level 16. Attach the knob cable to the
tension cable in the console mast.
Secure the tension knob to the console
mast with the washer (M5) and screw
(M5x70L). Tighten with the Phillips
screwdriver.
• Remove the four screws from the
back of the console. Connect the wire
harness to the plug in the back of the
console. Attach the console to the
console mast with the four screws
removed at the beginning of this step.
• Attach the water bottle cage with
the screws removed earlier in this step.
PINK BAG
3
STEP
X6100 X6000
X6000 ONLY