Venturer PLV76156 - Manual (Page 10)

E - 9
INSTALLATION
INSTALLING / REMOVING ThE BASE STAND
WARNING: The LCD Display is very fragile, and must be protected at all times when removing the
base stand. Be sure that no hard or sharp object, or anything that could scratch or damage the LCD
display, comes into contact with it. Do NOT exert pressure on the front of the unit at any time because
the screen could crack.
1. Disconnect all cables or cords connected to the unit.
2. Lay the unit down on a flat surface with the back side
facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam) beneath
the screen.
3. To install the base stand, place the base stand on the
mounting slot, push the stand till it locks.
4. To remove the base stand, keep pressing the locking area
of the base stand and pull downwards to release the base
stand.
MOUNTING ThE TV UNIT
1) Mark the correct mounting position on the wall.
2) Insert a fixing screw(s) at the marked position on the wall.
3) Align the slot hole(s) of the speaker over the screw and pull the TV downward until it is firmly
hooked.
NOTE
Remove the base stand before mounting the unit on the wall.
Press and pull downwards
PLV76156S7_IB_UL_090727.indd 9 7/28/2009 09:41:10