Venturer PLV76156 - Manual (Page 4)

E - 3
Before turning on your television set for the first time, be sure to place it on a solid stable surface. To avoid
danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct
the ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.
QUICK INSTALLATION
7 7/8"
2 3/8"
2 3/8"
TURNING ON ThE UNIT FOR ThE FIRST TIME
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
Make sure the TV antenna or CATV cable has been connected properly to the
TV ANTENNA input jack on the rear of the system.
1. Connect the TV antenna.
2. Connect the power cord.
3. Press the / ON button to turn on the unit.
4. Press the / button to highlight Antenna,
then use the ENTER or button to select
“Air”, “Cable STD”, “Cable HRC”, “Cable IRC”
or “Cable Auto“.
5. Use the / button to highlight Auto
Scan, then press the ENTER or button to
confirm.
6. The unit will immediately search all channels
for those with adequate signal strength and
store those channels with signals in memory.
The unit will take a few minutes to finish auto
scan and after this is completed, the unit will
switch to the first channel found.
To Stop Menu
Analog Air Channel 10
Analog Channels Found
Autoprogram Menu
Digital Channels Found
Progress(%) 5 0
0
Not Found
To Move To Select To Exit Enter Menu
OSD Language
Antenna
Initial Setup Menu
Auto Scan
Air
English
PLV76156S7_IB_UL_090727.indd 3 7/28/2009 09:41:04