Safety precautions – Venturer PLV76156 User Manual

Page 2

Advertising
background image

E - 1

PLACEMENT INFORMATION

• Do not use this unit in places which are extremely

hot, cold, dusty or humid.

• Do not restrict the air flow of this unit by placing it

somewhere with poor air flow, by covering it with

a cloth, by placing it on bedding or carpeting.

SAFETY INFORMATION

• When connecting or disconnecting the AC power

cord, grip the plug and not the cord itself. Pulling

the cord may damage it and create a hazard.

• When you are not going to use the unit for a long

period of time, disconnect the AC power cord.

CONDENSATION INFORMATION

• When left in a heated room where it is warm

and damp, water droplets or condensation

may form inside the equipment. When there is

condensation inside the unit, the unit may not

function normally. Let the unit stand for 1-2 hours

before turning the power on or gradually heat the

room and let the unit dry before use.

RATING PLATE LOCATION

The rating plate is located on the rear of unit.

FCC STATEMENTS

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.
This unit has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation.

This unit generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communication. However, there

is not guarantee that interference will not occur in a

particular installation. If this unit does cause harmful

interference to radio or television reception, which

can be determined by turning the unit off and on, the

user is encouraged to try to correct the interference

by one or more of the following measures:
- Reorient or relocate the receiving antenna.

- Increase the separation between the unit and

receiver.

- Connect the unit into an outlet on a circuit different

from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

- Shielded cables must be used with this unit to

ensure compliance with the Class B FCC limit.

- This television receiver provides display of

television closed captioning in accordance with

Section 15.119 of the FCC rules.

SAFETY PRECAUTIONS

The lightning flash with arrowhead symbol,

within an equilateral triangle, is intended to

alert the user to the presence of uninsulated

“dangerous voltage” within the product’s

enclosure that may be of sufficient magnitude to

constitute a risk of electric shock to persons.

The exclamation point within an equilateral

triangle is intended to alert the user to

the presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the appliance.

CAUTION : TO REDUCE THE RISK OF

ELECTRIC SHOCK, DO NOT REMOVE COVER

(OR BACK). NO USERSERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

CAUTION :

• DANGER OF EXPLOSION IF BATTERY IS

INCORRECTLY REPLACED. REPLACE ONLY

WITH THE SAME OR EQUIVALENT TYPE.

• TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT OF WALL

OUTLET, THEN FULLY INSERT.

• USE OF CONTROLS OR ADJUSTMENTS OR

PERFORMANCE OF PROCEDURES OTHER

THAN THOSE SPECIFIED MAY RESULT IN

HAZARDOUS RADIATION EXPOSURE.

The symbol for Class II

(Double Insulation)

WARNING :

• To reduce the risk of fire or shock hazard, do not

expose this unit to rain or moisture.

• Main plug is used as disconnect device and it should

remain readily operable during intended use.

• The unit shall not be exposed to dripping or

splashing and that no objects filled with liquids,

such as vases, shall be placed on unit.

• In order to disconnected the unit from the

mains completely, the AC power cord should

be disconnected from the mains socket outlet

completely.

• Battery shall not be exposed to excessive heat

such as sunshine, fire or the like.

WARNING:

Changes or modifications to this unit not expressly

approved by party responsible for compliance

could void the user authority to operate unit.

PLV76156S7_IB_UL_090727.indd 1

7/28/2009 09:41:02

Advertising