VIPowER VPM-6248T - Manual (Page 10)

VPM-6248T USER MANUAL 10
2-4 Mounting a 3.5-inch Drive in the MobileRACK
The VPM-6248T External Enclosure is factory configured with
the MobileRACK already installed.
Although these instructions specify a hard disk installation, the
steps are typical for mounting any device in the MobileRACK
drive case.
Step 1.
Separate the MobileRACK drive tray from the drive case installed
in the VPM-6248T External Enclosure by lifting the handle and
pulling the drive tray out.
2-3 LED Indicators
Red and green indicators are located on the front panel of the
VPM-6248T External Enclosure. The green LED is lit when the
power is ON. The red activity LED will flash when a HDD
installed in the MobileRACK is being accessed.
VPM-6248T Front Panel with the MobileRACK
Remove the MobileRACK Drive Tray
MobileRACK
LED Indicators
MobileRACK
Latch-Lock
VPM-6248T
LED Indicators
Green LED
(Power) Red LED
(HDD Access)
Remove the
MobileRACK
Drive Tray