VIORE PLC7V96 - Manual (Page 10)

1. Front View
2. Right View
1) CHARGE INDICATOR: The system is in charging state when red LED is lighting,
it will turn into green when full charged.
2) DC IN JACK: This is used for AC-DC adaptor input, the voltage range is 12V.
3) POWER SWITCH: This switch used to switch on/off the system, the system will enter fast
charging state if the DC adaptor connected in power off state.
4) EARPHONE JACK: This jack outputs analog audio L/R signal to earphone.
5) DIGITAL AUDIO OUT: This jack outputs analog coaxial audio signal.
6) AUDIO IN JACK: This jack is used for input analog audio L/R signal to system.
7) VIDEO IN JACK: This jack is used for input composite video signal to system.
8) AUDIO OUT JACK: This jack out puts analog audio L/R signal.
1) Antenna input: Connect to an external RF signal.
2) Speaker Left: The left speaker.
3) VOL+: Move around the menu screens or changing the volume in non-menu state.
4) CH+: Move around the menu screens or selecting the channels in non-menu state.
5) VOL-: Move around the menu screens or changing the volume in non-menu state.
6) OK: Confirm a selection within a menu.
7) CH-: Move around the menu screens or selecting the channels in non-menu state.
8) ASPECT: To change picture aspect.
9) MENU:Open the main menu window.
10) EXIT: Exit menu.
11) Speaker Right: The right speaker.
12) REMOTE CONTROL SENSOR: Receive the signal from the remote control
13) STANDBY:To set the portable TV to standby.
14) SOURCE: To select input source.
15) TFT screen: Display the TFT widescreen display.
16) External rod Antenna
Front and Rear panel illustration
1 3 2 5 4 6 7 8
1
2
3
4
5
6
7
8
9
10
11
12
13
15
14
16
9
ASPECT MENU STANDBY
SOURCE
CH+
CH-
V- V+ OK
C A R D R E A D E R
U S B
DIGITAL
AUDIO OUT VIDEO IN AUDIO IN AUDIO OUT OFF ON
CHARGE
DC IN 12V
AUDIO IN JACK and VIDEO IN JACK should be used at the same time.
AUDIO IN cannot be used for audio-only without an associated video connection