Maintenance, Getting started, Accessories – Venturer PVS7980 User Manual

Page 5

Advertising
background image

E - 5

heart shaped, octagonal, etc.). They may cause

malfunctions.

CLEANING THE UNIT

• Be sure to turn the unit off and disconnect the aC

power cord before maintaining the unit.

• Wipe the unit with a dry soft cloth. If the surfaces

are extremely dirty, wipe clean with a cloth that

has been dipped in a weak soap-and-water

solution and wrung out thoroughly. Then wipe

with a dry cloth.

• never use alcohol, benzene, thinner, cleaning

fluid or other chemicals. Do not use compressed
air to remove dust.

IMPORTANT NOTE

Before transporting the unit, remove the disc from
the disc compartment.

CLEANING THE DISC

A defective or soiled disc inserted into the unit

can cause sound to drop out during playback.

Handle the disc by holding its inner and outer

edges.

• Do not touch the surface of the unlabeled

side of the disc.

• Do not stick paper or tape on the surface.

• Do not expose the disc to direct sunlight or

excessive heat.

• Clean the disc before

playback. Wipe the disc

from the center outward

with a cleaning cloth.

• neVer use solvents such as benzine or

alcohol to clean the disc.

• Do not use irregular shaped discs (example:

MAINTENANCE

USING THE REMOTE CONTROL

• Point the remote control at the remote

SENSOR located on the unit.

• When using this unit in bright light, the infrared

REMOTE CONTROL SENSOR may not work

properly.

• the recommended effective distance for using

the remote control is about 16 feet.

TO CHANGE REMOTE BATTERy

BATTERy REPLACEMENT

When the battery becomes weak, the operating

distance of the remote control will be greatly reduced

and you will need to replace the battery.

Note:

• If the remote control is not going to be used for

a long time, remove the battery to avoid damage

caused by battery leakage corrosion.

• When discarding battery, environmental

problems must be considered and local rules

of laws governing the disposal of this battery

must be followed strictly.

CAUTION:

Danger of explosion if battery is incorrectly

replaced. Replace only with the same or

equivalent type.

GETTING STARTED

Remove the PVC sheet
before

operating

the

Remote Control.

WARNING:

• Do not dispose of batteries in a fire. they may

leak and/or explode.

• the battery should not be exposed to excessive

heat such as sunshine, fire or the like.

1. Open the battery

door.

2. Insert one

CR2025 (3V)
size battery.

Remote Control (with battery) ......... x 1

Car Power Adapter .......................... x 1

ACCESSORIES

PLEASE LOCATE THE INCLUDED ACCESSORIES.

to order replacement units, visit http://www.venturer.com

DC-AV Cable .................................... x 1

Straps ................................................ x 2

811-798191W012.indd 5

4/1/2008 5:00:57 PM

Advertising