Vidikron VL-37 - Manual (Page 43)

Operation
Vidikron VL-37 Owner’s Operating Manual 33
Save Settings (not available for RGB input): The DView lets you save image quality
settings for each input and supported resolution to a preset. You can recall this preset at a
later time by simply pressing a button on the remote control or using the Restore Settings
menu command (see below).
You should save changes to any of the following settings to a preset; otherwise they will be
lost when a new input source or resolution is selected:
• Aspect ratio
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Color temperature and white balance
Restore Settings (not available for RGB input): To recall a preset, choose Restore Settings
from the Picture Adjust menu and select “Custom,” “ISF Day” or “ISF Night.” Or, use the
corresponding buttons on the remote control.
Audio To adjust the DView audio settings, select Audio from the Main Menu and press ENTER.
Balance: To adjust the left/right speaker balance, select Balance from the Audio Menu and
press ENTER. Use the left- and/or right-arrow buttons to make one channel louder than the
other.
Equalizer: The DView has a five-band graphic equalizer that you can use to boost or cut
certain audio frequencies. To use it, select Equalizer from the Audio menu and press ENTER.
Select one of four equalizer presets -- Standard (flat), Music, Film or Speech -- or select
Custom to create your own according to taste. The five frequency bands are 100, 300, 1000,
3000 and 10,000 Hertz (Hz).
Surround: The DView has a “surround sound” mode that simulates a multi-channel sound
system. To use the surround mode, select Surround from the Audio menu and set it to On.
Audio
Balance
Equalizer
Surround
When Surround is set to On, the graphic equalizer is disabled.
Note