VIEWSONIC VPW4255 - Manual (Page 18)

OPERATING INSTRUCTIONS
Turning Power On and Off
• To turn the monitor power ON, press the main power
the SUB POWER button or the ON/OFF or ON button on
•
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the ON/OFF button on the remote control.
lamp
Power status Operating
Off Off
When the main power switch is set
to OFF.
Off
(standby)
When the main power switch is
On
When the main power switch is
Off
(Power Save)
When the main power switch is
When the indicating lamp lights orange or the message “No Sync.
Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen,
there is something unusual about the status of reception.
See “Power Save Mode” or “Symptoms That Seemingly Appear to be
Failures.”
AV1 AV2
RGB 1 RGB 2
AV3
MUTE VOL
VOL
AV4
AUTO PinP
OK
SIZE RECALL
MENU
ID ID SET
POWER OFF
button
POWER ON
button
POWER ON/OFF
button
SUB-POWER button
Main power switch
ATTENTION
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch before leaving the monitor out of
use for an extended period of time.
ViewSonic VPW4255 16
Indicator lamp
switch on the back of the unit to ON, and then press
or the ON/OFF, or OFF button on the remote
the remote control.
To turn the monitor power OFF, press the SUB POWER,
• During normal use, the main power switch is set in the ON
control, and then press the main power switch to OFF.
Indicator lamp
Red
Green
Orange
ON, and SUB POWER is ON.
ON, and SUB POWER is OFF.
ON, and SUB POWER is ON. The
unit is in Power Save mode.
Indicator
• If a power failure occurs while the main unit is running, it will
main power switch to avoid power surges upon recovery.
be powered on upon recovery from the failure. Turn off the unit's