Volvo XC90 - Manual (Page 70)

02 Instruments and controls
Left-side steering wheel lever
02
70
Lever positions
G026954
Turn signals, lane change position
Turn signals, position for normal turns
High beam flash
Toggle between high and low beams,
Home Safe lighting
Turn signals
When turning
Move the lever as far up or down as possible
(to position 2) to start the turn signals. The turn
signals will be cancelled automatically by the
movement of the steering wheel, or the lever
can be returned to its initial position by hand.
When changing lanes
The driver can automatically flash the turn sig-
nals 3 times by:
• Moving the turn signal lever up or down to
position (1) and releasing it.
• Moving the lever up or down to position (2)
and immediately back to its original posi-
tion.
NOTE
• This automatic flashing sequence can
be interrupted by immediately moving
the lever in the opposite direction.
• If the turn signal indicator flashes faster
than normal, check for a burned-out
turn signal bulb.
High/low beam headlights
Continuous high beams
1. Turn the ignition key to position II.
2.
With the light switch in position , (see
page 67) pull the turn signal lever toward
the steering wheel to toggle between high
and low beams.
High beam flash
1. Turn the ignition key to position II.
2. Pull the turn signal lever to position (3). The
high beams will remain on until the lever is
released.
Home safe lighting
When leaving your vehicle at night, home safe
lighting can illuminate the area in front of the
vehicle.
1. Remove the key from the ignition switch.
2. Pull the turn signal lever as far as possible
toward the steering wheel and release it.
3. Exit the vehicle and lock the doors.
The headlights and parking lights will illuminate
and remain on for 30
1 , 60 or 90 seconds. The
time interval can be changed by a trained and
qualified Volvo service technician.
1 Factory setting