VisionTek Theater 550 PRO - Manual (Page 11)

11
Remote control receiver unit for Media Center Edition version
Instructions: Attach the USB cable (included with product) into USB receptacle on receiver unit. Next, insert the other
end of the USB cable into an available USB port on your computer.
----------------------------------------------------------------------------------------------------------------------------------------------
IR Blaster for Media Center Edition 2005 version
To have Media Center change channels on a set top box such as a cable box or satellite receiver, you have to connect
Media Center to the box or receiver by using the IR blaster. This will allow you to access channels beyond channel
125 if using digital cable or satellite.
Note: The IR blaster bundled with this product is currently not supported by Snapstream Beyond TV
software.
Instructions: Please insert the male end of the plug into the either one of the receptacles on the receiver unit (shown
above). We recommend placing the receptor end of the IR blaster on top of your cable or satellite receiver set top box.
CHAPTER 3:
Installing Hardware - Media Center Edition
version (with remote control) only