VisionTek Theater 550 PRO - Manual (Page 6)

6
This chapter will guide you through the physical installation of your THEATER™ 550 PRO-based TV tuner card.
Quick Installation
Experienced users and system administrators can follow these brief instructions for installing the THEATER™ 550
PRO-based TV tuner card in the shortest possible time.
To perform a quick installation
1 Uninstall the drivers and software for any previous TV Tuner products if you have not already done so.
2 Shut down and disconnect the power from your computer system.
3 Remove any previously installed TV Tuner product.
4 Install your new THEATER™ 550 PRO TV tuner card.
5 Reassemble and connect your computer system.
6 Install the THEATER™ 550 PRO-based TV tuner card drivers and configuration software from the VisionTek
Installation CD-ROM by doing one of the following:
• Run through the automatic SETUP utility; or
• Start > Run > X:\SETUP.EXE (where X is the drive letter of your CD-ROM drive).
7 Windows XP Media Center Edition version card – run setup wizard by pressing green button on remote control.
or
7 Windows XP Snapstream “Subscriber Edition” version card – install SnapStream software.
CHAPTER 2:
Installing Hardware