Vantec UGT-IS100R - Manual (Page 12)

UGT-IS100R
Page 12
connection information, will be written to the replacement disk.
Rebuild Mirror Drive
When a failure to one member occurs, you will be notified by the
RAID BIOS during boot. The steps below will guide you in
rebuilding a failed mirror set.
1. Replace the failed drive(s) with one of equal or greater
capacity, start the computer.
2. During boot press
Ctrl+J to enter the RAID BIOS.
3. Select
Rebuild Mirror Drive press Enter.
4. Please use arrow keys
↑ and ↓to select the array you want to
rebuild, press
Enter.
5. Please use arrow keys
↑ and ↓to select the destination disk,
press
Enter.
6. When rebuilding is finished, select Save And Exit Setup,
press
Enter. When asked Save to disk &Exit (Y/N)?, press
Y to exit the BIOS.
BIOS Configuration
The 4+1 SATA II 300 IDE/PATA PCI-E Combo Host Card w/ RAID
& Port Multiplier BIOS will appear every time your system starts