Vantec UGT-IS100R - Manual (Page 7)

UGT-IS100R
Page 7
RAID Arrays
RAID Arrays are setup in the 4+1 SATA II 300 IDE/PATA PCI-E
Combo Host Card w/ RAID & Port Multiplier ’s BIOS.
There are four configurations supported:
RAID level/Type Configurations Number of disks
needed
RAID 0 Disk Striping 2 or 3 or 4
RAID 1 Disk Mirroring 2
RAID 0+1 Disk Striping
+ Mirroring
4
JBOD Disk Concatenation 2 or 3 or 4
RAID 0 (Striping)
1. As the BIOS boots press
Ctrl+J when prompted to enter the
RAID BIOS.
2. At the next screen select Create RAID Disk Drive, press
Enter.
3. Enter RAID name, press
Enter.
4. Please use arrow keys ↑ and ↓to switch the RAID level to
0-Stripe, then press Enter.
5. Please use arrow keys ↑ and ↓to switch the disk, use the