Vizio XMF1000 - Manual (Page 15)

7
7. Remove 3 lag bolts and 3 washers from the pouch
labeled LAG.
Place the other bracket (
part A) against the wall as shown, and
use a wrench to insert the lag bolts and washers into the
anchors. Do not insert the lag bolts completely. Leave 1/2” of the
bolts showing.
8. Push the bar through the openings in each bracket ( part A) as
shown.
Snap on the leveler ( part E) and verify that the bar is level.
Make any small adjustments, then use a wrench to tighten the 4
lag bolts completely.
13
8
Level Bar
Tighten Bolts The bar can be inserted from right to left or left to right,
depending on the end of the bar to which you would like
the handle attached.