Viking F20543 - Manual (Page 11)

20 21
1 2
Reattach door to range. Open door completely. Reattach hinge trim.
3 4
Remove pins from hole in hinges. Close door.
5
If the door needs to be adjusted, loosen hinge trim screws located in
step 2. Adjust the screws located between the door and kickplate using a
5/32” hex head allen wrench. After adjustment, tighten hinge trim screws.
Door Replacement and Adjustment
1
Install island trim. Attach with four screws provided.
2
3
Burner caps are packed in styrofoam top pack with the grates.
Place burner on top of range. Place burner grate on top of burner
cap and grate support.
Note: Arrow on burner cap must be pointing towards back of range.
4
3/
8”
3/8”
(0.
95
cm
)
(0.95 cm)
3/
8”
(0.
95
cm
)
Check that unit is level side to side
and front to back. The side trim must be 3/8” (0.95 cm)
above countertop. If unit is not level repeat steps 5-7
of “Leveling/Adjustments/Alignment” section.
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening.
Final Installation
Standoff Bracket Removal
DANGER
FIRE HAZARD
Backguards come standard with
standoff brackets which provide
a barrier between back of range
and rear wall. These must be in place for
adequate ventilation. The standoff brackets
may only be removed if range is installed
against a non-combustible wall.
Note: Standoff brackets can only
be removed if range is installed
against a NON-COMBUSTIBLE
wall. Please see the backguard
install guide for instructions on
how to remove the standoff
brackets.