Villaware NDVLEM1000 - Manual (Page 3)

villaware.com villaware.com
ExTENSION CORD USE
A short power-supply cord is provided to reduce the risk resulting from becoming entangled
in or tripping over a longer cord. An extension cord may be used if care is exercised in its use.
If an extension cord is used, the electrical rating of the cord must be at least as great as the
electrical rating of the appliance. The extension cord should be arranged so that it will not
drape over the countertop or tabletop where it can be pulled on by children or tripped over
unintentionally.
SAVE ThESE INSTRUCTIONS
Features:
Removable Drip Tray & Grid
3 2
Water Reservoir
Lid
Brew Mode
Button
Warming
Zone
Froth Mode
Button
Frothing Tube
Filter holder
Single & Double Filters
Measuring Scoop/Tamper
with wrench for removing tip
Special Cautions:
Caution: StEaM PrESSurE
In order to avoid possible burns to body
parts and/or other injury from hot steam
and water or damages to the unit, never
remove the filter holder while your
VillaWare® espresso/cappuccino maker is
brewing coffee or frothing. The control
knob should be in the OFF position before
you can remove the filter holder to make
additional cups of coffee.
Caution
Please follow these important safety
instructions while using your unit:
1 Before removing any of the parts and
accessories as directed by this manual,
make sure the control knob on the front
of the unit is turned to the OFF position,
press the center of the control knob for
the OFF position and unplug the
appliance.
2 Do not remove the filter holder at any
time during the brewing process. Scalding
may result.
3 Use caution when removing the filter
holder. The metal parts may still be very
hot. Also, there may be hot water floating
on the top of the filter. hold it only by its
handle and dispose the brewed coffee
grounds by using the filter retention clip.
4 If coffee does not drip from filter holder,
it may be blocked. Turn off the appliance
and allow it to cool down. The blockage
may be caused by the coffee being too
finely ground or tamped too tightly. See
“TROUBLEShOOTING” on Page 11.
5 WhEN CLEANING ThE FROThING TUBE:
Place a frothing pitcher or large cup (with
at least 11-ounce capacity) half full of
water under the frothing tube cap. Make
sure the tip of the frothing tube is
submerged in liquid before turning the
control knob to the Froth position. Froth
the water for approximately 15 seconds,
then wipe clean the frothing tube and cap.
notE: In order for your unit to work
properly time after time, clean the frothing
tip and tube after each use.
Center Power ON/OFF Button
with Light Ring to indicate
Power ON and Warming