Vinotemp VT-ODSBREF - Manual (Page 7)

7 1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
INSTALLATION INSTRUCTIONS
Before Using Your Unit
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• 2 Glass Shelves
• 2 Crisper Drawers
• 1 Crisper Glass Lid
• 1 Instruction Manual
• 4 Casters with Brakes
• Before connecting the unit to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from
handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
BUILT - IN INSTALLATION
• This unit has been designed for either freestanding or built-in installation.
• When built - in, it does not require additional clearance for top, sides or rear. However,
the front grill must not be obstructed.
OUTDOOR USE
• High ambient temperature over 110º F (43.4º C) may reduce the unit's ability to reach
low inner temperatures.
• The same applies if the ambient temperature drops below 40º F (4.4º C).
• It is recommended that the unit be shut off in temperature outside these limits.
CASTERS INSTALLATION
• Install the four casters provided into the unit’s bottom four threaded holes supplied.
• In order to release or lock the brake, follow the guide.