Vinotemp VT-ODSBREF - Manual (Page 8)

8
W W W . V I N O T E M P . C O M
Installing Your Unit
• Place your unit on a floor that is strong enough to support the unit when it is fully
loaded. To level your unit, adjust the leveling leg at the bottom of the unit.
• Locate the unit away from sources of heat (stove, heater, radiator, etc.). Heat sources
may increase electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized Vinotemp service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3
hours before placing food in the refrigerator compartment.
OPERATING YOUR UNIT
Setting the Temperature Control
• To adjust temperature, use the UP/DOWN buttons on the control panel.
• With one press of button, Buzzer sounds one time and indicator light turns on.
• Rapid Cool feature helps bring the temperature of your fridge down quickly and is
especially useful when the door has recently been opened or new non-cool items have
been added to fridge. Press the "Rapid cool" button for 1 second to turn on Rapid Cool
mode. Machine goes into rapid cool operation, when temp reaches 38°F, "rapid cool"
completes.
• Pressing the “Rapid cool” button again will also end the "rapid cold" function.
• Use the C/F button to toggle the temperature display between Celsius and Fahrenheit.
Note:
• Please allow 24 to 48 hours for the unit to cool to proper temperature on first use.
• To turn the appliance off, turn the switch at the bottom of the refrigerator to ”OFF”.