Vision Fitness T9000 - Manual (Page 6)

6
3
STEP
• Plug the large data cable into the
large plug connection on the lower
control board. Plug the small data
cable into the small plug connection
on the lower control board.
• Install the motor cover. Secure the
motor cover using the four (M5x20L)
screws.
PINK BAG
3
STEP
4
STEP
• Once the treadmill is plugged
in, you need to perform an Auto-
Calibration to assure maximum
performance.
DO NOT STAND ON THE
BELT WHEN PERFORMING THE
AUTO-CALIBRATION
• With the SAFETY KEY in place, hold
the ELEVATION UP and SPEED
DOWN buttons for five seconds. The
console will beep twice, “ENG0” will
appear in the Distance window, and
a number will apear in the Elevation
window.
• Press SELECT until “ENG3”
appears; this is for Auto-Calibration.
Press START to Auto-Calibrate.
• The treadmill will calibrate minimum
and maximum speed, and minimum
and maximum elevation. When Auto-
Calibration is complete, the treadmill
will reset to User’s start screen. This
process takes three to five minutes.
AUTO CALIBRATION