Vidikron Vision 120 - Manual (Page 52)

Installation
38 Vidikron Vision Model 120 Installation/Operation Manual
PRE
L
IMINAR
Y
Connecting 12-Volt Trigger
Outputs to External Theater
Equipment
If your Vision 120 is equipped with a CineWide with AutoScope system, connect the
AutoScope lens motor to a 12-volt trigger output on the VHD Controller; see Figure 3-17.
Similarly connect other 12-volt trigger-activated equipment (such as retractable screens or
screen masks) to the other trigger outputs.
For more information on using the VHD Controller triggers, refer to Triggers on page 62.
Figure 3-17. 12-volt Trigger Output Connections
➤
II I III
TRIGGERS
RS-232 / 485
ERFACE
Y
HD1 (RCA)
Y / G Vs Hs Pr / R Pb / B
HDMI
I I
INPUTS
DHD Controller
Rear Panel
AutoScope Lens Motor (Rear)
Tip = +12V
Sleeve = Ground
3.5-mm
mini plug
AC Input Power
Switch
Retractable Screen or other
12-volt trigger-activated
device