Vidikron Vision 75 User Manual
Vidikron Projectors
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- TWO YEAR LIMITED WARRANTY
- Important Safety Instructions
- Compliance Information
- 1 Introduction
- 2 Controls and Functions
- 3 Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens Mount
- Installing the AutoScope Lens Motor
- Installing the Fixed CineWide Base Plate (Prismatic Lens)
- Installing the Fixed CineWide Base Plate (Cylindrical Lens)
- 3.5 Mounting the Vision 65/75
- 3.6 Connections to the Vision 65/75
- Connector Panel Access
- Connecting Source Components to the Vision 65/75
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Output to External Theater Equipment
- Connecting to AC Power
- 3.7 Turning on the Power
- 3.8 Primary Lens Adjustments
- 3.9 Changing the OSD Language
- 3.10 Adjusting the Picture Orientation
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- Cylindrical Anamorphic Lens Installation and Adjustment
- Figure 3-17 . Cylindrical Anamorphic Lens Mounting Assembly - Exploded View
- Attach Lens Mounting Assembly to Lens Motor Carriage Plate
- Configure Lens Motor Trigger
- Adjusting the Horizontal (X) Lens Position
- Adjusting the Height (Y)
- Adjusting the Pitch (Angle)
- Adjusting the Yaw
- Adjusting the Geometry
- Focus
- Whitney (Prismatic) Anamorphic Lens Installation and Adjustment
- Cylindrical Anamorphic Lens Installation and Adjustment
- 4 Operation
- 4.1 Selecting Video Memory
- 4.2 Selecting an Aspect Ratio
- 4.3 Adjusting the Picture
- 4.4 Selecting An Input Source
- 4.5 Using Picture-In-Picture (PIP)
- 4.6 Using the On-Screen Menus
- 5 Maintenance and Troubleshooting
- 6 Serial Communications
- 7 Specifications