Vidikron Vision 75 - Manual (Page 49)

Installation
Vidikron Vision Model 65/Model 75 Installation/Operation Manual 33
3.8
Primary Lens Adjustments The Vision 65/75 gives you a great deal of control over the picture size, position and focus.
Focus and Zoom To focus the projected image, grasp the lens by the outer
ring and rotate it.
To make the picture smaller (zoom out) or larger (zoom in),
move the zoom tab in the appropriate direction.
Vertical Lens Shift To shift the projected image vertically, press the LENS button,
then press and hold the up or down-arrow (
, ) button.
3.9
Changing the OSD
Language The Vision 65/75 OSD language is initially set to English, but can also display the menus in
French, Spanish, Italian or German. To change the OSD language:
1. Press MENU.
2. Select Installation from the Main Menu and press ENTER.
3. Select Language from the Installation Menu.
4. Press or to select the desired language. (The change takes effect immediately.)
3.10
Adjusting the Picture
Orientation By default, the Vision 65/75 is configured for a “floor/front” installation, in which the
projector is installed upright and in front of the screen. If it is installed behind the screen
and/or mounted on a ceiling, you must change the picture orientation. To do this:
1. Press MENU on the remote control.
2. Select Installation from the Main Menu and press ENTER.
3. Select Orientation from the Installation Menu.
4. Choose Floor Rear, Ceiling Front or Ceiling Rear to match the installation method.
Zoom
in
Focus
Zoom
out
FOCUS LENS ZOOM
PIP ACT PIP +
LENS