Installing the autoscope lens motor, Remove projector front height adjusters, Assembly – exploded view – Vidikron Vision 75 User Manual
Page 36
20
Vidikron Vision Model 65/Model 75 Installation/Operation Manual
Installing the AutoScope Lens
Motor
Figure 3-5 shows the Vision 65/CineWide with AutoScope or Vision 75/CineWide with
AutoScope motor assembly.
Figure 3-5. Vision 65/CineWide with AutoScope or Vision 75/CineWide with AutoScope
Motor Assembly – Exploded View
Remove Projector Front Height Adjusters:
Place the projector upside down on a blanket
or other soft surface. Then, remove the two
height adjusters at the front of the projector
by turning them counterclockwise until they
come out.
➤
4
5
Screw, Phillips
Pan-Head,
10-32 x 1/2”
(4x)
1
AutoScope Lens Motor 2
Screw, Phillips Flat-Head,
10-32 x 1/4” (2x)
3
CineWide with AutoScope
Ceiling Mount Adapter/
Projector Stand, Right
CineWide with
AutoScope
Ceiling Mount Adapter/
Projector Stand, Left
7
Nylon Spacer,
5/8” diameter x
3/16” high (4x)
6 Screw, Phillips
Flat-Head,
Undercut,
M6 x 12mm
(4x)