Vidikron Vision 75 - Manual (Page 30)

Installation
14 Vidikron Vision Model 65/Model 75 Installation/Operation Manual
3.2
Quick Setup Table 3-1 gives a quick overview of the Vision 65/75 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 15
2
If installing a CineWide-equipped projector: Install
AutoScope lens motor or fixed CineWide base plate
(optional) 19
3 Mount the projector 25
4 Connect signal sources to the Vision 65/75 27
5 Connect external controller to RS-232 port (optional) 30
6
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional) 31
7 Apply power to the projector 32
8
Primary lens adjustments: focus, projected image size (zoom)
and position (shift) 18, 33
9 Change the OSD Language (optional) 33
10
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 33
11 Install CineWide anamorphic lens (optional) 34
12
CineWide lens adjustments: position, pitch (angle), geometry
and focus 35
13
Projector calibration: adjust the following for each input,
starting with Component 1; save settings when finished:
Aspect ratio
Brightness
Contrast
Color level
Tint
Input position 51 through 56
Note