Ceiling mounting plate - bottom view – Vidikron Vision 75 User Manual
Page 39
Vidikron Vision Model 65/Model 75 Installation/Operation Manual
23
Installing the Fixed CineWide
Base Plate (Prismatic Lens)
To install the fixed CineWide base plate on a Vision 65/CineWide or Vision 75/CineWide with
a prismatic anamorphic lens:
1.
Place the projector upside down on a blanket or other soft surface.
2.
Line up the two mounting holes on the CineWide base plate with those on the bottom of
the projector.
3.
If you are mounting the projector on a ceiling: Line up the four holes on the projector
ceiling mounting plate (included with the projector ceiling mount kit) with those on the
bottom of the projector.
4.
Secure the CineWide base plate (and ceiling mounting plate, if needed) to the projector
with the four, M6x12mm screws and washers provided with the CineWide lens base
plate. See Figure 3-8.
Figure 3-8. Vision 65/CineWide or Vision 65/CineWide with Whitney (Prismatic) Lens
Base Plate and Ceiling Mounting Plate - Bottom View
1. Do not use the mounting screws provided with the ceiling mounting
plate. Use only the hardware provided with the CineWide lens base
plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Washers under
Ceiling Mount Plate
(2 places)
Vision 65/CineWide or Vision 75/CineWide
with Lens Base Plate
Vision 65/CineWide or Vision 75/CineWide
with Lens Base Plate and Ceiling Mounting
Plate