4 operation, 1 turning on the power, 2 changing the osd language – Vidikron VL-57 User Manual
Page 35: Operation, Turning on the power, Changing the osd language, Pre l iminar y
Vidikron VL-52 and VL-57 Owner’s Operating Manual
23
PRE
L
IMINAR
Y
4.1
Turning on the Power
1.
Turn on your source components.
2.
Plug the female end of the supplied power cord into the AC receptacle on the rear of the
DView (AC 100V ~ 240V). See Figure 2-2.
3.
Connect the other end to your AC power source.
4.
Turn on the main power switch at the rear of the display. The power indicator lights red
to indicate that the DView is in “standby” mode.
5.
Press the ON button on the remote control to
turn on the display (or press the power button
on the side of the display). The power indicator
lights solid green.
6.
After a brief warm-up period (approximately 10
seconds), the DView will display an image.
4.2
Changing the OSD
Language
The DView OSD language is initially set to English, but can also display the menus in French,
Spanish, Portuguese or German. To change the OSD language:
1.
Press MENU.
2.
Select Setup from the Main Menu.
3.
Select OSD Language from the Setup Menu.
4.
Press
or
to highlight the desired language and press ENTER. The change takes
effect immediately.
4
Operation
4
5
1
2
3
6
7
8
9
OFF
ON