Figure 2-3 . vp-50 and vp-60 connector panel, 3. vp-50 and vp-60 connector panel, Pre l iminar y – Vidikron VP-42HD User Manual
Page 17
Vidikron PlasmaView Owner’s Operating Manual
7
PRE
L
IMINAR
Y
Figure 2-3. VP-50 and VP-60 Connector Panel
1.
POWER INPUT (100 to 240 VAC)
Connect the PlasmaView to power here, using the included power cord.
2.
EXTERNAL SPEAKER OUTPUTS
Connect optional, external speakers here. Maintain the correct polarity. Connect the
(positive) and
(negative) speaker wires to the EXT SPEAKER terminals on both the
LEFT and RIGHT channels. Please refer to the owner’s manual for your speakers.
3.
VIDEO1, 2 (RCA, S-Video)
Standard, Composite video and S-Video inputs for connecting a DVD player, satellite
receiver, camcorder, laser disc player or Super VHS (S-VHS) VCR.
4.
AUDIO1, AUDIO2, AUDIO3
Stereo, RCA-type audio inputs. You can associate each audio input with any video input
-- that is, specify which audio input becomes active when a given video source is
selected. For more information, refer to Audio Setup on page 32.
5.
DVD/HD1
DVD/HD2
Standard-definition (480i/576i) or high-definition (720p/1080i), YPrPb component
inputs for connecting a DVD player or high-definition TV source.
6.
PC/RGB (15-pin D-Sub)
Connect an analog RGB signal from a computer or DTV decoder here.
For best results, do not run your DVD player in progressive mode.
AC IN
RIGHT
+ -
LEFT
- +
5
6
7
8
10
9
4
3
2
1
Tip