Vidikron VP-42HD - Manual (Page 42)

Operation
32 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Audio Setup To adjust the bass, treble and left/right balance, or to assign the PlasmaView audio inputs to
the video inputs, select Audio Setup from the Main Menu and press MENU.
Bass: To adjust the low-frequency response, select Bass from the Audio Menu and use the
left- and/or right-arrow buttons to adjust the amount of bass in the audio signal.
Treble: To adjust the high-frequency response, select Treble from the Audio Menu and use
the left- and/or right-arrow buttons to adjust the amount of treble in the audio signal.
Balance: To adjust the left/right speaker balance, select Balance from the Audio Menu and
use the left- and/or right-arrow buttons to make one channel louder than the other.
Audio Input 1/2/3: This menu lets you assign each audio input on the PlasmaView to a video
input. Doing so causes that audio signal to be heard through the speakers when the
associated video input is selected.
For example, if a DVD player’s video output is connected to the DVD/HD1 input on the
PlasmaView and its audio output is connected to audio input 2, select AUDIO INPUT 2 from
the Audio menu. Then, use the left- and right-arrow buttons to assign it to DVD/HD1.
DVD/HD3 Input / DVD/HD4 Input: If you are using these inputs to connect an
HDMI-capable component, select HDMI to route the HDMI (digital) audio signal to the
speakers when DVD/HD3 or DVD/HD4 is selected.
Select INPUT 1-3 if the HDMI component’s analog audio out is connected to INPUT 1, INPUT 2
or INPUT 3.
Image Options Use the controls in the Image Options menu to perform advanced image quality adjustments
and access various other PlasmaView features.
Aspect Ratio: To change the aspect ratio (size and shape) of the projected image, select
Aspect Ratio from the Image Options Menu and press MENU. Select the appropriate aspect
ratio for the type of program material being viewed; refer to Table 4-1.
➤
BASS 0
TREBLE 0
BALANCE 0
AUDIO INPUT1 : VIDEO 1
AUDIO INPUT2 : DVD/HD 1
AUDIO INPUT3 : RGB
DVD/HD3 INPUT : HDMI
DVD/HD4 INPUT : HDMI
AUDIO SETUP
SEL. ADJ. RETURN EXIT
You cannot assign two or more audio inputs to the same video input.
Note
➤
ASPECT RATIO : LETTERBOX
V SHIFT 0
H SHIFT 0
V-SIZE 0
H-SIZE 0
COMPUTER : OFF
FINE PICTURE 0
PICTURE ADJ 0
IMAGE OPTIONS
SEL. ADJ. RETURN EXIT
When you change the aspect ratio, save the change to a preset
afterwards. Otherwise, the change will be lost when a different input is
selected. (The aspect ratio is saved for each input and resolution
separately.) For information about saving settings, refer to Memory
Setting on page 31.
Note