Vertek/XTC SCORPION 2330 User Manual
Page 36
CONNECTIONS
Speakers
If only one pair of speakers are being used they should be connected to channel
A. Observe the correct polarity when you connect speakers or poor quality sound
will result. Also, be careful to make sure there are no shorts in the speaker wiring
and the correct impedance speakers are used.
For one pair of speakers, each speaker may be between 4 and 16 ohms. When 2
pairs of speakers are used, each speaker must be 8 or 16 ohms. For multiple
speaker systems (eg. ceiling speakers) use transformers to convert the system to
100V line or wire the speakers in a series/parallel combination to ensure the load
presented to the 2330 is not lower than specified.
Caution: Improper connection may cause damage to the unit.
1
2
3
4
+ - - +
+
-
Right Speaker
1
2
3
4
+ - - +
+
+
-
-
8 ohm
8 ohm
4 ohm
4 ohm
4 ohm
4 ohm
4 ohm
4 ohm
+
+
+
+
+
-
-
-
-
-
Example 1
Connecting
2 speakers
to a channel
Example 2
Connecting 6
speakers to a
channel without
using transformers
36
36
2330 - SCORPION OPERATOR MANUAL