Rear panel – VocoPro DA-7909RV User Manual

Page 10

Advertising

Rear Panel

1. RS 232 Interface Jack - This jack is used by the factory in the event of future firmware

upgrades.

2. Effects Loop IN/OUT Jacks (RCA) - Connect to an external equalizer or effects unit with L/R

RCA Ins and Outs.

3. Loop On/Off Switch - Use this to turn on or bypass the Effects Loop IN/OUT channel.

4. Center Out Jacks (RCA) - Acts as a monitor output and must be connected to a powered

speaker/monitor or amplifier. The center out channel can be set to either Mic Only or Music

Only. See the operations section for detailed instructions on switching between Mic Only and

Music Only.

5. Pre Out Jacks (RCA) - This channel outputs both microphone vocals and music to a non-powered

audio input device with L./R RCA audio inputs.

6. External Controller Connection - For use with an external controller (not included).

7. Microphone Input Jacks 4 and 5 - Connect 2 additional microphones here using ¼” microphone

cables. NOTE: MIC 4 volume is controlled by the MIC 1/4 control on the front panel and MIC 5 is

controlled by the MIC 2/5 control.

8. Voltage Selector - This selector toggles between 110-120V and 220-240V power settings.

NOTE: Please ensure that this switch is set to the correct position, matching the receiving

AC outlets power supply before plugging it in an operating it. Failure to do so may cause severe

damage to the unit and void your product warranty.

LA VERNE, CA — USA

MODEL: DA 7909RV

www.vocopro.com

��

��

��

��
��

��

�

��

��
��

��

Advertising

Popular Brands

Popular manuals