VocoPro DA-7909RV - Manual (Page 24)

22
Storing Custom Effects Settings (M1, M2, M3, M4)
The DA-7909RV allows you to set up to 4 custom effects settings using the M1, M2, M3, M4 memory buttons
on the remote control.
1. Adjust the effects settings to your desired specifications.
2. Hold down the CANCEL button on the front panel for 10 seconds. The display screen will say SAVE TO X
3. Press the memory button on the remote control (M1, M2, M3 or M4) that you want to save this
specific setting to. NOTE: Saving the new setting to a memory slot will erase the previous setting
to that slot.
4. Follow steps 1-3 for each memory slot.
Advanced Operations
Setting the CENTER OUT Output
The CENTER OUT channel can be set to either play microphone vocals only or music only.
To change the CENTER OUT:
1. Press the C. MODE button on the front panel ONCE.
2. Use the MUSIC MASTER VOLUME control on the front panel to switch between MUSIC and MIC which
will be displayed on the display panel. Select MUSIC for music-only or MIC for microphone-only.
Resetting the Effect Settings to the Original Factory Settings
1. Hold down the button on the front panel. NOTE: The effects must be reset using the button
on the front panel, not on the remote control.
2. The display screen will say RESET once the original factory settings have been restored
�� �� �� �� �� �� �� �� �� ��
����
������ ������
����
�� �� �� �� �� �� �� �� �� ��
����
������ ������
����
Detail of Front Panel (Mic Only)
Detail of Front Panel (Music Only)